![]() 2a) Plug the power supply into an outlet near the PC where the software is installed. 2) Plug the yellow cable connector into the power supply port. 1b) Use the lock slider to lock the connector in place. 1a) Plug the yellow cable connector into the port. When prompted to connect your camera: 1) Remove the hatch from the back of the camera. 2) Connect the other blue cable connector into an open port on your router. 1a) Then, plug the network adapter into the power outlet. When prompted to plug in the network adapter: 1) Plug one end of the blue cable connector into the network adapter. ![]() The network adapter and power supply must be plugged directly into your wall outlet. Surge protectors are built-in to the network adapter and power supply and protect the cameras. Network Adapter / Power Supply Install Note Do NOT plug the network adapter or power supply into a surge protector or power strip as they interfere with the cameras. 4) The First Run Wizard will guide you through the next steps of setup. 3) Logitech Alert Commander software will open. Alternatively, you can download the latest version at 2) You may be asked to reboot the PC. The installer will check for the latest version of the software.1) Insert the Software Install CD and follow the instructions during the install. Be sure to comply with the laws in your country, state, and locality when using Logitech Alert products and services. If prompted to allow Logitech Alert access to the network, you should always answer “Yes” or “Allow.” Legal Warning Certain uses of security camera products and audio devices, such as employee monitoring, surreptitious viewing and recording of images and/or audio, or the use, publication or distribution of image and/or audio recordings, are prohibited or restricted by country, state and local laws. 2) During installation, we will test your PC’s firewall settings. 1) Read all instructions before beginning the installation.
0 Comments
Leave a Reply. |